Fork Damper Rod Holding Tool 10.3mm and 12.7mm Engine Build Tools which makes life easy when

which makes life easy when dragging it out from some low to the ground cruiser

1off JIS No 1 75mm shaft

Without the proper tool it's so easy to mark the stanchions

Professional 150mm diagonal side cutters with ergonomic grip with 1000volt protection

- Units: Nm

Fork Damper Rod Holding Tool 10.3mm and 12.7mm Engine Build Tools which makes life easy whenThis holding tool is used in conjunction with a fork spring compressor Designed to slide in under the damper rod nut to hold the spring down to allow the nut and fork cap to be separated Double ended 10. 3mm & 12. 7mm Used to assist in fork service and repair Use in accordance with the fork manufacturers instructions