Fibre-reinforced plastics. Methods of producing test plates - Contact and spray-up moulding Ingestion-build-81111 with their associated tolerances

with their associated tolerances

NOTE Sieves with a mesh size smaller than 32 μm are not practical and are likely to become blind during use

BS EN IEC 61000‑3‑2:2019 includes some technical changes with respect to BS EN 61000‑3‑2:2014

The method is applicable to all types of steels with niobium contents up to 1

Austenitic and duplex stainless steels

Fibre-reinforced plastics. Methods of producing test plates - Contact and spray-up moulding Ingestion-build-81111 with their associated tolerances1 Scope This part of ISO 1268 specifies methods for preparing reinforced plastics test plates either by contact moulding or by spray up moulding. It applies exclusively to glass reinforcements. It is intended to be read in conjunction with ISO 1268 1.