E3D High Precision Heater Cartridge 3D Printer Filament In less than 15 seconds

In less than 15 seconds MODIFI3D will reach around 300ºC (572ºF) and is ready for use

good results were achieved using standard PLA parameters with standard build surface preparation (blue tape

PolySupport™ is a material designed to overcome of the problems in a desktop FDM/FFF 3D

but we had good luck with a slow 1st layer at 230C on cold blue tape and 210C thereafter for a balance of strength and aesthetic

ePC is flame retardant has been tested and analyzed by the manufacturer and was found to meet the requirements of UL94-V2

E3D High Precision Heater Cartridge 3D Printer Filament In less than 15 seconds12v or 24v 30w or 40w Ceramic Heater Cartridge A powerful heater for your HotEnd, with improved reliability and highly precise temperature output. A high tolerance canister boosts thermal efficiency, while a built in Molex connector makes removing your HotEnd from your 3D printer easier than ever. Key Features Highly precise temperature output Improved Reliability Attached to a connector for quick release High tolerance canister for maximum thermal