Jack Hammer Adapter Compression Points Transfer the length of both

Transfer the length of both lines

The point is screwed into the PVC pipe and cuts threads on the inside of the pipe much like a tap

( Remove The point after marking the pipe)

The trajectory of penetration has three settings

It is designed to absorb lateral forces that the point will experience as it comes in contact with debris from different angles along it's route

Jack Hammer Adapter Compression Points Transfer the length of bothThis part is used to connect the Bullet Mole to a jack hammer so that the jack hammer can drive the Bullet Mole. It basically has 2 holes in it. One larger hole that will slide over the impact cap and one smaller hole that will recieve the sawed off blunted, 1 1 8" hex bit connected to the jackhammer. Eeither an electric or pneumatic jack hammer having a 1 1 8" hex shank may be used with the jack hammer adapter. NOTE: An Idea is to use an old. worn