Safety of machinery. Safety requirements for extrusion presses for steel and non-ferrous metals Ingestion-build-47553 These methods are primarily intended

These methods are primarily intended for testing the sheets specified in EN 438-3

ISO/IEC 27010 is a sector-specific supplement to ISO/IEC 27001:2013 and ISO/IEC 27002:2013 for use by information-sharing communities

e) the pressure exerted

This part of IEC 60695 presents a general characterization of small-scale test flames and associated confirmatory tests based on copper block calorimetry

BS 8549:2006 gives recommendations for the management

Safety of machinery. Safety requirements for extrusion presses for steel and non-ferrous metals Ingestion-build-47553 These methods are primarily intended1 Scope This European Standard applies to: extrusion presses from the exit side of the heater through associated handling, cooling and quenching equipment including, e. g. the puller, the hot saw, the run out table, the stretcher, the cold saw, cold saw table and or coiler when incorporated into the equipment, to a point where the extruded product is passed to associated finishing equipment. It specifies the health and safety requirements at all