Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with 7/24 taper without automatic tool changer included-in-kit The report gives supplementary guidance

The report gives supplementary guidance on the use of all parts of ISO 5167 and information on the use of essential secondary instrumentation

1 to 15 TiO2 0

for internal wiring

the thermal efficiency is obtained by the direct method of test and is established to within a tolerance of ± 2 % points

To ensure the safety of equipment it is recommended that design advice is obtained from a competent person and that appropriate risk-benefit assessment are carried out

Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with 7/24 taper without automatic tool changer included-in-kit The report gives supplementary guidance1 Scope This part of ISO 10649 specifies the dimensions of cutter arbors with parallel key and tenon drive with 7 24 tapers without automatic tool changers.