Heat shrinkable low and medium voltage moulded shapes - General requirements (IEC 62677-1:2017) Ingestion-build-223009 Protect and enhance the organization’s

Protect and enhance the organization’s reputation and credibility

Provisions are made for the testing of sufficient specimens to permit the calculation of the brittleness temperature on a statistical basis

ISO 204 is concerned with the method used to measure such material behaviour

BS EN 14286:2008 Aluminium and aluminium alloys

TPEG-PTI) is assigned a unique number that is called the Application IDentification (AID)

Heat shrinkable low and medium voltage moulded shapes - General requirements (IEC 62677-1:2017) Ingestion-build-223009 Protect and enhance the organization’s1 Scope This document is applicable to heat shrinkable low and medium voltage moulded shapes in a range of configurations and materials suitable for insulation, environmental sealing, mechanical protection, electrical conductance, anti tracking and strain relief for power cable terminations, joints and stop ends. It specifies the test methods and material requirements. The most commonly available shapes are as shown in the Annex A. Materials which