Carbide Pin - 90° Tip angle, Standard Length STD Parts

Carbide Pin - 90° Tip angle, Standard Length STD PartsCarbide stylus pin with a 90 tip angle Standard Length: 52mm Carbide hardness: HRA92 Suitable for marking all metal surfaces up to 62HRC This is better for finer marking deeper mark on softer metals (ie. aluminium) or can help to achieve more depth on harder materials. You can regrind the tip or we can offer that service if you require, just get in touch.

If access to the workpiece is a key requirement - check out the windowless version

You can regrind the tip or we can offer that service if you require

80mm(D) x 180mm(W)

See Markinbox Software for more information

For position workpieces

If you require a case for a Patmark unit click here

Other pin assembly components are common with the standard Markinbox solenoid components

but it will also get worn down fairly quickley and so is not recommened for the purpose steel marking in general OR in order to achieve greater depth in typical steel marking operations

This is sharpest tip angle and is recommended for plastics only

Pin life is dependant on how hard your material is

It has two rare earth magnets

This is splash proof cover and not 100% water proof